Owner’s Manual
Tilt Flat Screen
Wall Mount
MODEL: DWM1323SE
CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY. SERIOUS INJURY OR
PROPERTY DAMAGE MAY OCCUR!
75x75
100x100
27”
15kg
MAX
(33lbs)
MAX
Русскоязычная версия настоящего руководства представлена на веб-сайте компании
Copyright © 2013 Tripp Lite. All rights reserved.
13-09-228-9332A6-EN.indd
1
10/29/2013 12:53:49 PM
Component Checklist
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to
DWM1323SE (x1)
4mm Allen Key (x1)
5mm Allen Key (x1)
Package M
M4X14 (x4)
M5X14 (x4)
Package W
Anchor Bolt (x4)
Concrete Anchor (x4)
3
13-09-228-9332A6-EN.indd
3
10/29/2013 12:53:50 PM
1a. Mount on Wood Stud Wall
1
2
Find and mark the
exact location of
mounting holes
3
Drill pilot holes
Anchor Bolt
Screw the wall
mount onto
the wall
WARNING
• Make sure that mounting screws are anchored into the center of the studs.
Use of a stud finder is highly recommended.
• Installers are responsible to provide hardware for other types of mounting situations.
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
4
13-09-228-9332A6-EN.indd
4
10/29/2013 12:53:52 PM
1b. Mount on Solid Brick and Concrete
1
Mark the exact
location of
mounting holes
2
Drill pilot holes
Concrete Anchor
Anchor Bolt
Screw the wall
mount onto
the wall
WARNING
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
5
13-09-228-9332A6-EN.indd
5
10/29/2013 12:53:54 PM
2. Attach the Display to the VESA Plate
M4X14
M5X14
Lift the display and match the holes on your display with the holes on the mount. Secure your display to
the mount by tightening screws
Tighten all screws but do not over tighten.
3. Adjustment
5mm Allen Key
Tighten the adjustment screw by using Allen Key provided to fix the tilting angle
6
13-09-228-9332A6-EN.indd
6
10/29/2013 12:53:56 PM
3. Adjustment
Tension is pre-set at the factory. If too tight or too loose, you may adjust the tension by loosening or tightening
the head and arm adjustment bolts.
180°
180°
+15°
-15°
4mm Allen Key
Adjust to the desired location or tilt.
Maintenance
• Check that the bracket is secure and safe to use at regular intervals(at least every three months).
7
13-09-228-9332A6-EN.indd
7
10/29/2013 12:53:56 PM
13-09-228 93-32A6_RevA
8
13-09-228-9332A6-EN.indd
8
10/29/2013 12:53:59 PM
|