W-187 141 095006 NA
The Automatic Collection
24 Hour Hand
Minute Hand
Hour Hand
1
2
3
Power Indicator
Calendar
HOW TO SET THE TIME
Unscrew crown all the way out and turn to correct time. Push crown in
to restart.
Watches with date: Note correct time of day (A.M. or P.M.) for proper
date function. (Please see illustration above for 24-HR dial.)
HOW TO SET “FAST DATE”
3-Position Crown: Unscrew crown until you reach position “2” and turn
counterclockwise until correct date appears.
NOTE: Date may need to be manually
1 2 3
updated at the end of each month by fol-
14
lowing above procedure (otherwise it will
continue to 31 and then roll over to 01
each month).
HOW TO WIND YOUR WATCH
Turn crown in position 1 to begin winding clockwise.
POWER RESERVE
The watch is self-winding. If you wear your watch every day, there
should be no need to wind it every 24 hours, unless the power reserve
shows “LOW”.
The maximum power reserve is at least 36 hours. The power reserve
indicator shows you how much power remains. You should wind your
watch when the indicator hand is near “LOW”.
BRACELET ADJUSTMENT
Sliding Clasp Bracelet
Open locking plate. Move clasp to desired bracelet length. Exert pres-
sure while holding locking plate and slide clasp back and forth until it
engages in grooves on underside of bracelet. Press locking plate down
until it snaps closed. Clasp can be damaged if excessive force is used.
Foldover Clasp Bracelet
Find spring bar that connects bracelet to clasp. Using a pointed tool
(Fig. 1), push spring bar in and gently twist bracelet to disengage.
Determine wrist size, then insert spring bar in correct bottom hole
(Fig. 2). Push down on spring bar, align with top hole and release to
lock in place (Fig. 3).
Fig. 1
Fig. 3
Fig. 2
BRACELET LINK REMOVAL
Removing Links: Place bracelet upright
and insert pointed tool in opening of link.
Push pin forcefully in direction of arrow until
link is detached (pins are designed to be dif-
ficult to remove). Repeat until desired number of links are removed.
Reassembly: Rejoin bracelet parts. Push pin back into link in opposite
direction of arrow. Press pin down securely into bracelet until it is flush.
SOLID LINK BRACELET
Removing Links: Using a very small
screwdriver, remove screws by turning
counterclockwise. Repeat until desired
number of links are removed. Do not
remove links adjacent to clasp.
Reassembly: Rejoin bracelet parts and insert screw in end of opening
where it was removed. Turn screw clockwise until tight and flush with
bracelet.
(continued on reverse)
|