USB to serial
digital device
adapter
Introduction
Congratulations on your purchase of the Targus USB to Serial Digital Device Adapter. This ultra portable
expansion USB-RS232 directly connects to your computer via the Universal Serial Bus (USB) port. The
USB-RS232 features easy connectivity for traditional serial and others USB devices.
System Requirements
Hardware
• PC with a Pentium® processor or equivalent
• USB V.1.1 compliant port
• CD-ROM Drive
Operating System
• Windows® 2000 / XP / Vista™
WARNING
You must install the driver
software BEFORE
connecting the adapter to your
computer otherwise the adapter
will not work properly.
Installing the Device and Driver
To use the Targus USB Port Adapter, you must first install its driver software onto your computer. Once the
driver has successfully installed, you will need to restart your computer.You can then connect your Targus
USB port adapter.
NOTE
When connecting a
Card Reader
PDA
serial device to the
adapter, you must disconnect
then reconnect the adapter’s
USB connector in order for the
new device to work properly.
Labels Writer
Notebook
Barcode Reader
Digital Camera
Desktop
Fingerprint Verification
Technical Support
For technical questions, please visit
US
Telephone: 0800-633-222
Australia
New Zealand
Product Registration
Targus recommends that you register your Targus accessory shortly after purchasing it. Go to: http://www.targus.com/registration.asp
You will need to provide your full name, email address, phone number and company information (if applicable).
Warranty
Targus warrants this product to be free from defects in materials and workmanship for one year. If your Targus accessory is found to be defective within that
time, we will promptly repair or replace it. This warranty does not cover accidental damage, wear and tear, or consequential or incidental loss. Under no
conditions is Targus liable for loss of, or damage to a computer; nor loss of, or damage to, programs, records, or data; nor any consequential or incidental
damages, even if Targus has been informed of their possibility. This warranty does not affect your statutory rights.
Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Statement
Tested to Comply
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
• Reorient or relocate the receiving antenna;
• Increase the separation between the equipment and receiver;
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected;
• Consult the dealer or experienced radio/TV technician for help.
Changes or modifications not authorized by the party responsible for compliance could void the user’s
authority to operate this product.
Quick Start
PA088U / 410-0089-001B
Microsoft, Windows and Windows Vista are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.
Features and specifications subject to change without notice. All trademarks and registered trademarks are the property of their respective owners.
All rights reserved. © 2007, Targus Group International, Inc. and Targus, Inc.
|