wireless
keypad and
opitcal mouse
combo
specifications subject to change without notice.
© 2006 Targus Group International, Inc. and Targus, Inc.
USER GUIDE
PAKP003U / 410-0015-001A
30
TARGUS WIRELESS
KEYPAD AND
OPTICAL MOUSE
COMBO
Introduction
Congratulations on your purchase of the Targus wireless
keypad and opitcal mouse combo. This combo set offers
the latest technology for interference free operation with 27
MHz wireless connection and 4,096 IDs per channel. Both
keypad and mouse feature on/off switch and auto power
saving management for effective power conservation.
Contents
In addition to this user’s guide, this package contains:
› Targus Wireless Keypad
› Targus Wireless Optical Mouse
› USB Receiver
› USB extension cable
› 4 AAA batteries (2 for mouse, 2 for keypad)
› Carrying pouch
System Requirements
Hardware
®
®
• PC with an Intel Pentium processor or equivalent
• USB 1.1 interface
Operating System
®
• Windows 98SE/Me/2000/XP
2
Targus wireless keypad and opitcal mouse combo
NOTE: The third button and the scrolling wheel of
the mouse only work with the operating systems listed
above. If you use the mouse with a different operating
system, it will lose its enhanced features and function
as a standard, two-button mouse.
Installing the Batteries
Optical Mouse
1
Remove the battery cover from the top of the mouse by
pressing the top center (over the Targus logo) and
sliding it back.
Removing the battery cover
2
Insert the supplied batteries , making sure that the
positive (+) and negative (-) ends of each battery match
the polarity indicators inside the battery housing.
WARNINGS: When replacing the batteries, you may use
alkaline or other heavy-duty NiMH batteries. Never
combine an alkaline with a NiMH battery in a device.
Avoid mixing new and used batteries in a device.
3
4
Slide the battery cover back into position until it “clicks”
firmly into place.
Turn on the mouse by sliding the on/off switch on the
bottom of the mouse to the “on” position.
The optical sensor, located on the bottom of the mouse,
glows red.
3
Targus wireless keypad and opitcal mouse combo
Wireless Keypad
1
Remove the battery cover located on the bottom of the
keypad.
2
Insert the supplied batteries , making sure that the
positive (+) and negative (-) ends of each battery match
the polarity indicators inside the battery housing.
Setup Key
setup
Power
Num
Lock
Switch
BkSp
/
*
Num Lock
LED
7
8
9
-
Home
PgUp
4
5
2
6
+
1
3
End
PgDn
Enter
.
0
00
Ins
,
Del
3
Turn on the keypad by sliding the Power switch on the
right side of the keypad to the “on” position.
Connecting the Receiver
Plug the USB receiver into an available USB port on your
computer.
Setup Key
Lock LED
The “Lock LED” light turns on.
You are now ready to set the identification code to establish
a communication link with the receiver.
4
Targus wireless keypad and opitcal mouse combo
Setting the Identification Code
After your computer detects the USB receiver you must set
the ID code between the receiver and the mouse as well as
between the receiver and the keypad BEFORE you can use
them. To do this, do the following:
NOTE: Make sure that your computer is turned on and
has detected the USB receiver before you set the ID
code.
Optical Mouse
1
2
Press and release the setup key on the receiver. The
Lock LED light turns off.
Press the setup key on the bottom of the mouse.
Setup Key
power swtich
When the LED on the receiver is lit, the mouse is set up
with an ID and the receiver is locked.
You are now ready to use the mouse.
5
Targus wireless keypad and opitcal mouse combo
Wireless Keypad
1
Press and release the setup key on the receiver again.
2
Press the setup key on the keypad.
When the light emitter diode (LED) on the receiver is lit,
the keypad is set up with an ID and the receiver is
locked. You are now ready to use the keypad.
Using the Keypad
Activate Num Lock (LED illuminated)
Definition of the keys:
Num
Lock
Bk Sp
/
*
7
4
1
0
8
9
6
3
.
-
5
+
2
Enter
00
Deactivate Num Lock
Definition of the keys:
Num
Lock
Bk Sp
/
*
Home
PgUp
-
+
End
Ins
PgDn
Del
Enter
6
Targus wireless keypad and opitcal mouse combo
Power Management
To power the keypad and mouse on and off, slide the on/off
switch to the desired position.
When power is on, the mouse goes into “power saving
mode” after 4 minutes of inactivity. To activate the mouse,
move the mouse or press any button.
To save battery power, turn off the keypad and mouse while
traveling or when you’re not using them.
CAUTION: Removing the batteries will require you to
reset the ID code.
Operating Hints
For optimal performance and RF reception:
• Place the receiver at least 20 cm away from all electrical
devices, such as your monitor, speakers or external
storage devices.
• If necessary, use the supplied extension cable to keep the
receiver away from the computer. Plug the receiver into
the extension cable, and the extension cable to the
computer.
• Avoid using the optical mouse on a metal surface. Metals,
such as iron, aluminum or copper, shield the radio
frequency transmission and may slow down the mouse’s
response time or cause the mouse to fail temporarily.
• The mouse will enter a suspend mode at the same time
your computer does. To activate the mouse, press any of
the buttons.
• If your computer has a metal case that contains aluminum
or magnesium, use the optical mouse to the side. The
display panel may interfere with the radio frequency signal
if you use the mouse directly in front of the computer.
7
Targus wireless keypad and opitcal mouse combo
• Never use the optical mouse on a glass or mirrored
surface as these surfaces will cause the mouse to fail
temporarily.
• To maximize battery life, use the optical mouse on a white,
or light colored surface. Dark surfaces cause the mouse’s
LED to glow brighter, which causes the battery to
discharge more rapidly.
Comfortable Usage
Research suggests that physical discomfort and injury to
nerves, tendons, and muscles may be related to repetitive
motion, an improperly set up work area, incorrect body
posture, and poor work habits.
To reduce the risk of injury, follow these precautions:
• Stand, stretch, and move around several times every hour.
• Switch hands while performing tasks. Use shortcut keys
to avoid repetitive or awkward mouse movements.
• Relax your shoulders and keep your elbows at your sides.
Adjust the keyboard’s position so that you don’t have to
stretch to reach it.
• Adjust your position so that you don’t have to bend your
wrists to type; avoid placing your wrists on a sharp edge.
If you feel discomfort or numbness in your hands, wrists,
arms, shoulders, neck, or back while typing, consult a
qualified medical professional.
Things to Remember
Batteries
General
• You must reset the ID code every time you change the
batteries.
8
Targus wireless keypad and opitcal mouse combo
• To extend the life of your batteries, turn off the mouse and
keypad while not in use and during travel.
Power Saving Mode
• The mouse’s power saving mode feature activates after 4
minutes of non-operation. To activate the mouse, move
the mouse or press any button.
Troubleshooting
What do I do if the mouse does not work?
• Make sure that the polarity of the batteries is correct. The
positive (+) and negative (- ) ends of each battery must
match the positive (+) and negative (-) connections in the
battery housing.
• Check that the receiver’s USB connector is firmly
attached to the USB port on your computer.
• Verify that the device drivers are installed.
• Make sure you have established a communication link
between the mouse and its receiver. See “Setting the
Identification Code”.
9
Targus wireless keypad and opitcal mouse combo
When I use the mouse, other wireless devices work
more slowly or fail tempor arily – what should I do?
• The mouse may cause interference with any cordless,
radio-based device that operates at 27 MHz, such as a
telephone, baby monitor, or toy. To reduce interference,
move the mouse’s receiver and the base unit of the
affected device as far away from each other as possible.
• You can also reset the mouse’s identification code. The
mouse has 4096 identification codes that allow the
mouse and its receiver to operate without interference
from other radio frequency devices. To do this, see
“Setting the Identification Code”.
What do I do if the response time of the mouse is
slow or the mouse intermittently stops working?
Try one or more of the following:
• Increase the distance between the mouse’s receiver and
the rest of your computer equipment.
• Increase the distance between the mouse’s receiver and
the base units of other wireless devices.
• Turn off any wireless devices and their base units that are
near the mouse’s receiver.
• If you are using the mouse on a metal surface, move it and
the receiver to a non-metal surface. Metals, such as iron,
aluminum or copper, shield the radio frequency
transmission and may slow down the mouse’s response
time or cause the mouse to fail temporarily.
• Replace the batteries.
I can’t use the mouse while another RF mouse is in
use – what should I do?
• Reset the identification code. See “Setting the
Identification Code”.
10
Targus wireless keypad and opitcal mouse combo
Technical Support
For technical questions, please visit:
US
Australia
Email: [email protected]
Telephone: 1800-641-645
New Zealand Telephone: 0800-633-222
Product Registration
Targus recommends that you register your Targus accessory
shortly after purchasing it. Go to:
provide your full name, email address, phone number, and
company information (if applicable).
Warranty
Targus warrants this product to be free from defects in materi-
als and workmanship for one year. If your Targus accessory is
found to be defective within that time, we will promptly repair
or replace it.This warranty does not cover accidental damage,
wear and tear, or consequential or incidental loss. Under no
conditions is Targus liable for loss of, or damage to a devices
nor loss of, or damage to, programs, records, or data; nor any
consequential or incidental damages, even if Targus has been
informed of their possibility. This warranty does not affect your
statutory rights.
Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must
accept any interference received, including interference that
may cause undesired operation.
11
Targus wireless keypad and opitcal mouse combo
FCC Statement
Tested to Comply
This equipment has been tested and found to comply with the limits of
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and if not installed and
used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
•Reorient or relocate the receiving antenna;
•Increase the separation between the equipment and receiver;
•Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected;
•Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not authorized by the party responsible for
compliance could void the user’s authority to operate this product.
Declaration of Conformity
Hereby, Targus, declares that this device is in compliance with the
essential requirements and other relevant provisions of Directive
1999/5/EC.
Intel and Pentium are registered trademarks of Intel Corporation. Windows is a
registered trademark of Microsoft Corporation. All other trademarks are the property of
their respective owners. © 2006, Targus Group International, Inc. and Targus, Inc.,
Anaheim, CA 92806 USA.
12
|