TIC Outdoor Receiver Amplifier AMP10
am/fm/cd/mp3/ipod/karaoke player
TIC Outdoor OmniSpeakers Feature
Weatherproof Design
Perfect for outdoor speaker listening
without interfering with interior audio
or other speaker set ups
“Safe” 12v power supply
Powers 4x outdoor speakers!
Input CD, MP3 or iPod music!
Wireless speaker capable
2x microphone inputs
Outdoor Karaoke!
AM/FM listening!
Select pre-set radio stations
Domestic or commercial installs
ABS impact resistant enclosure
LCD menu
Black/ silver finish
©TIC Corporation U.S.A.
Index…
Introduction ………………….……………
Component List …………………….…….
Legend …………..……… ……………....
Pre-Installation …………………… ……..
Exterior Installation ………………………
Maintenance ………………………………
Customer Service ………………..………
Warranty …………………………..………
Trouble Shooting ……...…………….…...
3
4
5
6
7
7
7
7
9
Technical Specifications …………….….. 10
Thank You for purchasing another high quality audio
product from TIC Corporation. Please read the enclosed
installation guidelines carefully and thoroughly to ensure
years of trouble free service from your new TIC exterior
audio products.
Carefully unpack your new TIC exterior product and save
all packaging materials for possible future use. Check that
your new TIC product contains all system parts detailed in
the Components list. Do not attempt to operate, install or
use your new TIC product if any components appear
missing or damaged. If so, please notify TIC Corporation or
your TIC Dealer as soon as possible.
!WARNING! to avoid possible suffocation or injury please
keep all plastic bags away from children and pets.
Component List…
1x
1x
1x
1x
2x
1x
1x
1x
AMP10 Outdoor Receiver Amplifier
AM/FM Antennae
2.5 to 2.5mm jack plug cable
Mains to 12v power cord & transformer
Speaker connection cables
New product offer (enclosed with literature)
Owners Instruction Guide Manual
Warranty Card
Need Professional Help?
Please read this owners guide carefully before installation. Failure to follow
these instructions fully or incorrect installation may damage your new TIC
products and any third party equipment used in your new system installation.
This may also Void any warranty for your new TIC products. If you are unsure
of your ability to fully understand and fully complete the installation of this TIC
product, please consult a professional installer.
Note: TIC Corporation always recommends that you test your product and its
components prior to exterior installation. Test your components near a mains
power and, if required, receiver amplifier source somewhere convenient,
perhaps inside. Ensure all components are working smoothly and correctly
before exterior placement and operation.
Legend functions…
Front;
AMP10 Receiver Amplifier
Basic Functions
1 & 7 Volume increase or decrease
2 & 8 Radio Tuning
3 Scan Stations
4 AM or FM select
5 Mode
6 Fascia on/ off or pause
9 Preset Stations
10 Select input device
11 Mono or Stereo output
*below: inputs are self described
WARNING!
There is no requirement for the customer to
open this unit for any kind of operation or
maintenance. Doing so will void the warranty.
Ensure rear main power switch is in the “off”
position when not in use.
Keep the unit away from high temperatures,
excessive water, chlorinated solvents or
enclosed areas that prevent natural air flow
cooling or excessive dirt and particulate matter.
Avoid any shocks, high vibration or sudden
impacts or collisions to the unit.
The AMP unit is weatherproof to a certain point
and not expected to be exposed to excessive
moisture.
The 12v power connection at the unit is fairly
water tight however the mains power 3-prong
plug is not, anymore than other exterior devices
like your electric lawnmower or other electrical
exterior use equipment. Please take precautions.
Pre-Installation…
1. Carefully unpack your new AMP10 receiver Amplifier and check all
supplied components carefully
2. TIC always recommends that our customers test their new purchase
prior to any exterior installation to ensure their familiarity with the
units basic operation before installation
3. Once you have tested your new TIC product to ensure everything is
working properly prior to exterior installation, please find a safe, level
and stable surface on which to operate you new receiver amplifier
Disclaimer;
TIC Corporation will in no way be held responsible for the improper or
unsecured installation of this product. Any and all damage arising from the
installation or use of this product is the purchaser and final installer’s sole
responsibility.
An Important note on Polarity!
Pleasure proper polarity when connecting your new TIC outdoor
speakers. This is very important and will result in poor sound reproduction
and possibly equipment damage if not connected correctly. This is normally
avoided by ensuring + to + and – to – or as sometimes color coded Red to
Red and Black to Black from your amplified source to your speakers
respectively.
Exterior Installation…
This TIC AMP10 exterior receiver amplifier can connect to and operate
three different sound sources at any one time.
Step by step…
1. Installation of your amplifier should consider a safe, off the ground,
dust free position not too far from a mains outlet and not exposed to
excess water, dust, particulate matter or human traffic conditions
2. Connect any pre-run outdoor speakers or output devices to your
AMP10 receiver amplifier
3. Connect any input devices such as your CD/ MP3/Ipod players etc. to
your AMP10 receiver amplifier
4. Connect the rear 12v power cable to your AMP10 and then tighten the
connection securely.
5. Connect the rear cable to the supplied 12v transformer.
6. Connect the power mains cable to the 12v transformer and then to the
wall mains 120/110v. Please be especially cautious with the integrity
of this connection to dangerous mains power. Ensure its in a safe and
dry environment.
7. Switch the unit “on” using the rear silicone material clear covered
rocker switch
8. Switch the unit “on” using the front fascia on/off/ pause push switch
9. Choose your listening “Mode”. Note: the unit is factory preset in Radio
mode to begin initially
10. Select desired input device CD, MP3 or radio/ mic’s input/ output
11. Test the unit using as many “modes” of operation as you can to
ensure a correct trouble free exterior installation
Sit back & Enjoy!
TIC Corporation wishes you many years of pleasure
from your new TIC Corporation exterior audio product
General Operation…
Power the unit “on” by using both the rear silicone covered
rocker switch and then the front fascia touch switch the unit will
default to FM receiving mode. You may then use the Mode
switch to cycle to a different sound source.
Volume; press Vol+ or Vol- to control Volume. Press and hold
down to continuously change volume levels
Pause; press the on/off switch which will first cycle through
Pause or Play
Switching Mode(s); Initially the unit is in Radio receiving Mode.
The front panel LCD screen will show FM/AM. Simply press the
Mode button to switch to “Aux”. When choosing CD the display
will show CD. Press the Mode button again to switch to the
input source you desire
Radio; while receiving press and hold the Tune+ or Tune-
buttons and again to stop auto searching
Radio Station Settings; press the Tune+ or Tune- to change
one frequency at a time (FM: 0.5mHz, AM: 9kHz)
FM/AM selection; press the AM/FM button to switch between
bands
Automatic Radio Station Searching; press the Scan button to
initiate automatic station searching mode. There will be a slight
pause as a station is found. Press any button to exit
Radio Stations Preset Memory; when listening to your am/fm
radio, to save the current radio station your enjoying, press the
Preset button to initiate station storage. On the display it will
show “CH01”. Press the Tune+ or Tune- to select which
number preset you prefer.
There are 30 channels to choose from in both the AM and FM
bands.
To exit this selection process, simply press the Select button. If
the system remains idol it will also automatically exit this
function
Select Preset Station(s); while listening to your radio, press
the Select button and the LCD display will show “CHXX”. The
CHXX shown will represent the current preset channel. Press
the Tune+ or Tune- to select from your pre stored radio
stations. Press the Select button again to exit from your
selections
Karaoke; please simply plug your microphones in and enjoy!
Maintenance…
Occasional maintenance of your TIC products cannot hurt and may help
greatly. Inspect the installation area regularly removing and twigs, dirt or
particulate matter from impeding or building up around the unit or the output
grill area. The units may be cleaned using very mild detergents like
dishwashing liquid if desired. A hose with clean water may also be used but
please avoid using high pressure or forcing water into the grill or acoustic ports.
In very cold climates with moderate to heavy snowfall an old trick from the
major theme parks we supply world wide is to place a plastic bag over the unit
for the winter or periods it may be not in use or under such snowfall.
Customer Service…
For any additional help please contact TIC Corporation at (800) SPX-OMNI, on
happy to assist you at any time. Also please visit our website for FAQ
(frequently asked questions) and full contact information.
Warranty Period…
TIC Corporation offers a full, UCC approved, one year full parts and labor
warranty on all its products as standard however there are other 3 and 5 year
warranties in use with various TIC authorized Dealers world wide. Please check
your enclosed Warranty card or your Dealer receipt to find out which one
applies to you. Also please note TIC Corporation General Terms & Conditions
Installation Notes…
Some notes on your new AMP10 outdoor receiver amplifier…
Problem
Cause
Power plug is
incorrectly connected
Output device wire is
incorrectly connected
Correction
Check and secure the
power connections
Check and secure the
output devices
Power on but the LCD
screen does not
display?
connections
Choose a suitable
sound source
Use the Mode button to
choose an operating
sound source
No Sound?
The Speaker
connection is
unsecured
Check and secure the
connection(s)
Trouble Shooting… (general output devices, speakers)
Problem
Please Check
Check the speakers are connected to the cable
correctly.
No Sound
Check the speaker cable is connected to the receiver
amplifier correctly.
Check the receiver amplifier is powered “on” at the
mains, is not on “mute”, has no headphones attached
and that the Channels used for the exterior speakers
(usually A or B) is in operation.
Refer to the owners guide that came with your
receiver amplifier.
Most initial problems are connectivity, please try a
different connection cable to your outdoor speakers
or equipment.
Check the “balance” control on your receiver
amplifier.
Check all connections and cable to the inoperable
speaker.
No Sound from one
speaker
1. Disconnect the “working” speaker from the
receiver amplifier connection/ channel. Switch the
cord from the non-operating speaker from its current
connection to the “working” speaker connection. If
the speaker now works the problem is your receiver
amplifier.
2. Reconnect as original. Remove the speaker cable
at the “working” speaker directly and connect it
directly to the non-working speaker. If the speaker
now works the problem is somewhere in the original
speaker cable.
3. If the speaker still does not work the problem is the
speaker.
One speaker sounds
distorted, lower
Follow same procedure as above for “No Sound”.
volume or “different”
Check the “tone” setting on your receiver amplifier.
Adjust the Treble and Bass settings on your receiver
amplifier.
Treble or Bass
Check the connections carefully from the amplifier to
your speakers and ensure correct Phase (+ to + and
– to – accordingly). Poor sound replication is
expected from a speakers or speakers out of polarity
or phase.
TIC AMP10 Outdoor Receiver Amplifier
General Specifications
Power Supply
110V/DC 12V 4A
AM/FM Tunable
frequency range
FM:87.00MHz-108.00MHz
AM:522KHz-1620KHz
Tunable S/N
Continuous/peak
Frequency Response
AMP S/N
FM 75dB AM 41dB
2.5W/5.0W
40HZ-16KHZ
>80dB
Sensitivity
1W/1m:80dB
4-8ohm
Impedance
AM/FM built in, CD/MP3/other to
phono, ipod/mics/ wireless to jack
Input
Output
Supplied
4x speakers
Waterproof connector
Black
Color
Unit Dimensions
Unit Weight
Pack Dimensions
Pack Weight
UPC
7.9”L×4.7”W×2.2”H
2.6lbs
16.1”W×15.0”L×13.4”H(24PCS)
64lbs(24PCS)
7 35120 50000 9
8pc.
Master Carton
TIC Corporation engages in continual product research and development, new
materials, production methods and design improvements. TIC Corporation therefore,
reserves all rights to change or improve products specifications without notice.
TIC Corporation
15224 East Stafford Street
City of Industry, CA. 91744-4418 U.S.A.
Tel: (626) 968-0211 (5 lines) Fax: (626) 968-1363
|